Assembly & Commissioning of Machines & Systems
Forus Supports Clients During Start-up of Capital Projects.
Clients often engage Forus to support start-up and commissioning activities.
Start-up success requires a team approach with active planning and participation by all stakeholders. Completion of a well-designed, safe and best-in-class facility delivered on time requires the early development of a commissioning and start-up plan and schedule based on a systems approach and establishment of system turnover dates to support it.
In support of start-up planning, each process unit is divided into systems and sub-systems to facilitate their completion, pre‑commissioning and commissioning. This approach requires close coordination among the client, engineering, process licensors (if applicable), suppliers, construction and the start-up team for an orderly turnover, commissioning and start-up while minimizing the impact to ongoing operations.
Forus develops a detailed Project Commissioning Manual early in the engineering phase that outlines the client's and Forus's approach and methodology to implementing seamless commissioning and turnover.
Professional assembly and commissioning
Assembly, installation and finally commissioning of the machines and equipment constitute an important step towards successful operation of a plant. To best serve our customers and respond to their individual requirements, FORUS offers a wide variety of services.
From assembly inspection to complete assembly, FORUS offers a full spectrum of services. We do not only put plants into operation, but also offer further support in the following areas if required:
- Complete assembly
- Assembly management
- Assembly supervision
- Final assembly inspection
- Cold commissioning
- Hot commissioning
- Support after successful commissioning
- Modifications after Installation
- Software Operations
- Checking System Operations
The benefits of our assembly and commissioning service
We make sure that there is only a short period of time between the delivery of the machines and the start of production. By having your plant installed by our well-trained fitters you avoid possible long-term damage due to improper assembly of the equipment. Furthermore, we provide support by an experienced technician also after acceptance of the plant.
Plants and Machines by FORUS
FORUS manufactures machines and turnkey plants for the international market. If you decide in favour of a machine or plant from FORUS, you get quality "International Quality". Complete turnkey
- Wood, Chipboard and MDF Industry
- Paper and Packaging Industry (recycling)
- Wood, Chipboard and MDF Industry
- Chemical and Petrochemical Industry
- Oil & Gas and Energy Industry
- Metal Industry
- Mining and Soil Industry
- Automotive Industry
- Air Separation Plant
- Water Treatment Industry
- Ship Building Industry
- Cooling Industry
Recycling plants are supplied to well-known companies throughout the world. For the recycling industry, we offer complete Paper and Packaging Industry (recycling), domestic waste pelleting plants and Wood, Chipboard and MDF Industry. In all areas, we are among the leading international manufacturers.
After delivery of our equipment and machines they will be assembled and commissioned by our experienced technicians and specialists. The scope of our activities depends on your needs and can range from small service calls, through supervised assembly (monitoring and technical direction) to complete installation. Over the entire setting-up period our experts shall always assume full responsibility for the equipment and shall always be at your side when needed.
Our staff then check the installed systems for compliance with requirements. In mutually performed test runs we then determine how well the projected capacity can actually be fulfilled. Our highly qualified employees carry out the mechanical and electrical fine-tuning necessary for commissioning the systems.
Our activities do not just restrict to installing systems and putting them into operation, since we can also offer training for your own staff. It is important to us that we can make your staff as familiar with the system as possible. For this reason, we seek your close involvement already when we put the various parts of your system into operation. In this way we can ensure from the first day of production that your staff are able to operate the plant as intended, to maintain it independently and to keep it working. In addition, your staff shall also be able to restart the system independently in the event of any minor malfunctions so that downtimes can be prevented.
We will still of course continue with our assistance even after the installation and commissioning of your machinery and systems. You shall always be able to rely on our efficient and rapid service.